High Precision Thermal Fuse Resistor MF Series Low Error Metal Film Resistor

 
Type

 
ITEM

 
PERFORMANCE AND QUALIITY ACCEPTANCE

 
TEST METHOD

 
Resistance to temperature
coefficient

 
 
 
 
PPM/℃ ＜ 50PPM
 
 

 
R – RO 106
PPM/℃ = *
RO T- T0
 
R = Measured resistance(Ω)at T
T ℃ 
Ro = Measured resistance (Ω)at To
To ℃ 
T = Measured test temperature(℃)
To = Measured base temperature( ℃)

 
Short time overload

 
±(0.5%R + 0.05ohm)
Shall be no mechanical breakage
 
 

 
AC or DC voltage 2.5times the rated
Voltage for 5 seconds .

 
Voltage endurance

 
 
No breakdown or flashover
 

 
Lay the resistor on the 90° angle metal “V” peak is 1.42 times as much as insulate voltage .
 

 
Terminal strength

 
Shall be no mechanical breakage

 
Pull test apply 3.5KG force to the lead in the direction of lead axis for 30±5 seconds.
 

 
Heat resistively
against soldering

 
 
 
±(0.5%R + 0.05ohm)
Shall be no mechanical breakage
 

 
Dip the lead in to a solder bath having a temperature of 350℃ ± 10℃ up to 3±0.05mm from the body of the resistor and hold it for 3.5±0.5seconds leave the resistor ,at room temperature 1 hours after ,then Measure.

 
Load life test

 
 
±(1%R + 0.5ohm)
Shall be no mechanical breakage
 
 

 
In the constant temperature chamber 70℃ ,apply rated voltage for 1 hour and shut voltage for 0.5 hour and repeat this cycle for 1000 hours,
 

 
Solder ability

 
 
≥95%

 
Dip the lead in to a solder bath having a temperature of 260℃±5℃.
Time:5± 0.5seconds.
 

 
Humidity load test

 
 
 
≤± (2% R+ 0.1ohm)
Shall be no mechanical breakage
 
 

 
In temperature chamber 40℃±2℃,relative humidity 90 – 95%,Apply rated voltage 1.5hour and shut voltage 0.5 hour repeat this cycle for 1000 hours, leave in room temperature for 1 hour after test,
 

 
Vibration

 
 
 
 
 
Shall be no mechanical breakage
 

 
set a resistor at the vibration table and vibrate 10HZ—55HZ 10HZ/s. with 1.5mm amplitude in 1 min. when the change of frequency shall be completed uniformly. the vibration shall apply to 3 directions,vertical and horizontal to the axis of resistor each for 3h.
 

 
Endurance at upper-limit temperature

 
 
≤±(2%R+0.1Ω)

 
At 125 ℃ temperature, duration of 1000h